The controller will first attempt to obtain a gateway IP address using the option with the lowest cost. If you select more than one dynamic gateway type, you must also define a cost for the route to each gateway. In the Dynamic section, click the DHCP, PPPoE or Cellular checkboxes to select one or more dynamic gateway options. You can define a dynamic gateway using DHCP, PPPOE or a cell uplink interface. In the Cost field, enter a value for the path cost. In the IP Address field, enter an IP address in dotted-decimal format. To add a new static gateway, click the Add button below the static IP address list. Navigate to Configuration > Network > IP > IP Routes. The following configurations assign a default gateway for the controller.
![vlan router configuration vlan router configuration](https://www.mustbegeek.com/wp-content/uploads/2015/10/Router-On-A-Stick.png)
(host) (config) #show vlan Configuring the Default Gateway To confirm the port assignments, use the show vlan command: (host)(config-if) #switchport trunk native vlan In this example, click port 25.įor Native VLAN, select a VLAN from the scrolling list, then click the left (// In the Port Selection section, click the port that will connect the controller to the network. Navigate to Configuration > Network > Ports. The following procedures configures a Gigabit Ethernet port as trunk port. (host) #show vlan mapping Assigning and Configuring the Trunk Port To confirm the VLAN pool status and mappings assignments, use the show vlan mapping command: Use the CLI to add existing VLAN IDS to a pool. You can create, update, and delete a VLAN pool using the WebUI or the CLI. (host) #show vlan Creating, Updating, and Deleting VLAN Pools A good practice is to use the Apply button to save changes to the running configuration and, after ensuring that the system operates as desired, click Save Configuration. Clicking the Apply button saves changes to the running configuration but the changes are not retained when the controller is rebooted. In the WebUI configuration windows, clicking the Save Configuration button saves configuration changes so they are retained after the controller is rebooted.
VLAN ROUTER CONFIGURATION UPDATE
You can create and update a single VLAN or bulk VLANS using the WebUI or the CLI. Creating, Updating, and Viewing VLANs and Associated IDs (For example, the uplink ports connected to a router are usually Gigabit ports.) In the example configurations shown in this section, a controller is connected to the network through its Gigabit Ethernet port 1/25.Ĭonfigure a default gateway for the controller.
![vlan router configuration vlan router configuration](https://s8182.pcdn.co/wp-content/uploads/2014/07/070214_1824_InterVLANRo19.png)
VLAN pooling should not be used with static IP addresses.Īssign to the VLAN the ports that you will use to connect the controller to the network. With the VLAN pool feature you can control your configuration globally. This creates redundancy where one controller has to back up many other controllers. For example, policies and virtual application configurations map users to different VLANs which may exist at different controllers. A VLAN pool consists of two more VLAN IDs which are grouped together to efficiently manage multi- controller networks from a single location.
VLAN ROUTER CONFIGURATION HOW TO
This section shows how to use both the WebUI and CLI for the following configurations (subsequent steps show how to use the WebUI only):Ĭreate a VLAN on the controller and assign it an IP address. You must follow the instructions in this section only if you need to configure a trunk port between the controller and another layer-2 switch (shown in Deployment Scenario #3: APs on Multiple Different Subnets from Controllers). Configuring a VLAN to Connect to the Network Configuring a VLAN to Connect to the Network